These 3d-printed zoetrope sculptures were designed by John Edmark, and they only animate when filmed under a strobe light or with the help of a camera with an extremely short shutter speed. He shares about the project:

These are 3-D printed sculptures designed to animate when spun under a strobe light. The placement of the appendages is determined by the same method nature uses in pinecones and sunflowers. The rotation speed is synchronized to the strobe so that one flash occurs every time the sculpture turns 137.5º—the golden angle. If you count the number of spirals on any of these sculptures you will find that they are always Fibonacci numbers.

For this video, rather than using a strobe, the camera was set to a very short shutter speed (1/4000 sec) in order to freeze the spinning sculpture.

If you happen to have a 3D printer handy, you can find instructions on how to make these over on Instructables.

And don’t forget, if you’re looking for a piece of original art to hang on your walls, check out artFido HERE!